News

A new standard to help with the fight against blindness

Doctor performing an eye examination

Glaucoma is the leading cause of blindness, and now an EMPIR project has provided metrological validation for instruments that detect the main risk factor

The World Health Organization has named glaucoma as the leading cause of irreversible vision loss, responsible for 37.5 % of all blind people world-wide.

In its early stages glaucoma has no symptoms and can only be detected by an increase in intraocular pressure (IOP), the pressure inside the eye caused by fluid build-up.
As IOP is the only treatable risk factor for the disease it is essential that medical instruments that measure IOP are metrologically validated.

However, this isn’t the case for IOP non-contact measuring devices called tonometers. Despite being fast and easy to use – with eye pressure measured by ‘gusts’ of air blown at the eye – there is no universal standard for calibrating these devices. Each manufacturer uses in-house standards for calibration making measurement comparison between different types of instrument challenging. There is also a lack of critical metrological parameters such as repeatability, stability and measurement uncertainty.

This lack of independent metrological calibration can potentially result in imprecise measurements affecting the diagnosis of the disease and the subsequent treatment of glaucoma.

Thanks to the EMPIR project Developing research capabilities for traceable intraocular pressure measurements (16RPT03, InTense) the situation is now changing.

During the now completed project the Slovak University of Technology in Bratislava (STU BA) developed a virtual digital model of the eye’s cornea which formed the basis for the construction of a real mechanical model.

This ‘artificial eye’ – consisting of a piston pressure generator and a pressure chamber with an artificial cornea – was built to act as a new transfer standard for tonometer calibration.

The calibration ability of the new standard was tested in an interlaboratory comparison against  a set of silicone eyes commonly used in calibration and verification procedures, by STU BA and CMI, the Czech National Metrology Institute (NMI) and supported by SMU, the NMI of Slovakia. After the comparison a clinical trial took place, at the Ružinov Hospital in Bratislava, Slovakia.
These comparisons confirmed the high potential of the eye model, setting the stage for the successful development of the artificial eye as a universal transfer standard in the near future.

The new standard, along with the new calibration facility for calibration of eye tonometers also developed in the project, will go a long way to providing better protection against glaucoma in Europe.

Dominik Pražák (CMI) who coordinated the highly successful project has said about the work :

” We hope that this universal transfer-standard will one day replace the fragmented, specialized solutions and will contribute to a uniform, easier and cheaper assurance of the metrological traceability of the intraocular pressure measurements.”

This EMPIR project is co-funded by the European Union's Horizon 2020 research and innovation programme and the EMPIR Participating States.

Want to hear more about EURAMET?

Follow us on LinkedIn and Twitter

Select your area of interest
EMPIR project on atmospheric aerosol traceability publishes paper in Metrologia
2022-12-08

Improving methods and instrumentation to better understand the contribution of atmospheric aerosols to climate change more

EMPIR project produces new device for magnetic field observation
2022-12-06

An EMPIR project has produced a new device that can observe the dynamic magnetic fields created inside steel sheeting during energy production more

EMPIR project supplies time and frequency dissemination for aerospace industry
2022-12-01

An EMPIR project has extended the size of its time and frequency dissemination test-beds to supply two prominent aerospace companies more

EMPIR project on biomethane contributes to several ISO projects
2022-11-29

Methods proposed by the project have been accepted by an ISO working group, as part of a standards collaboration with CEN more

Comprehensive guide to detecting mercury in the environment publicly available
2022-11-23

Mercury is highly toxic to humans, animals and ecosystems. Its oxidised forms are particularly harmful but prior to the work of this project lacked va... more

Page 1 of 197.