CALIBRATION OF DIAMETER STANDARDS (EUROMET.L-K4.2005)

Project Description

Proposal, 11 October 2004

Diameter of rings, plugs and a sphere will be measured.

The measurements will be done in 2 groups. Those whose uncertainty is less (or equal) than 0,3 micrometer/50 mm belong to the Group 1 and the those who have more than 0,3 micrometer (k=2)/50 mm belong to the Group 2.

The link between the two groups will be served by 2 laboratories (NPL, IMGC) from group 1 participating in both groups.

Group 1: SMD, MIKES, BNM, PTB, IMGC, METAS, NMi-VSL, NPL, SP

Group 2: BEV, CMI, OMH, GUM, MIRS, CEM, UME, DFM, NML, METROSERT, EIM, FSB, INM

Artefacts will probably be a ring and a plug of diameter 40 - 50 mm, a ring and a plug of diameter 3-4 mm, and a ceramic sphere of 25-30 mm diameter. A selection of artefacts is in progress.


Proposers

Group 1. (u <= 0,3 µm):

Proposer's name: Gian Bartolo Picotto
Address: IMGC, Strada delle Cacce, 73 IT-10135 Torino
Telephone: 39 011 3977 469
Fax: 39 011 3977 459
E-mail: g.picotto@imgc.cnr.it

Group 2. (u > 0,3 µm):

Proposer's name: Edit Banreti
Address: OMH, Németvölgyi út 37-39 H-1124 Budapest
Telephone: 36 1 458 5997
Fax: 36 1 458 5927
E-mail: ebanreti@omh.hu

Further Information

This comparison follows the previous EUROMET 384 (EUROMET.L-K4) comparison.

 

Participants from outside EUROMET are welcome to participate in the project.