EURAMET Calibration Guides and Technical Guides

Calibration Guides

EURAMET has published multiple calibration guides intended to improve harmonisation in the calibration of measuring instruments.
All guides can be downloaded as a pdf version.

A list of former versions of calibration guides and the differences between versions can be found here

Annotations

No. 1 | Calibration of Stylus Instruments for Measuring Surface Roughness | TC-L
The Guide is no longer available. TC-L recommends the use of DKD-R 4.


No. 5 | Coordinate Measuring Machine Calibration | TC-L
The Guide is no longer available. Superseded by ISO 10360 series: Geometrical Product Specifications (GPS) - Acceptance and reverification tests for coordinate measuring machines (CMM).
http://www.iso.org/iso/iso_catalogue/catalogue_tc/catalogue_detail.htm?csnumber=18418


No. 9 | Measurement and Generation of Small AC Voltages with Inductive Voltage Divider | TC-EM
The Guide has been withdrawn since it was outdated and no longer used.


Note:
The calibration guides were originally published by EAL Committee 2 (Calibration and Testing activities). They have been revised and re-published by the corresponding EURAMET Technical Committees (TC). The copyright of all guides is held by © EURAMET e.V. 2007.

Further information:
For further information and to suggest topics for new guides, please contact the EURAMET Secretariat or the TC Chair of the corresponding EURAMET Technical Committee.

Technical Guides

Notification about updates of EURAMET Calibration Guides and Technical Guides

To receive information about updates of EURAMET Calibration Guides and Technical Guides please subscribe here